NORDICA MATT is a full-matt house paint for exterior wooden surfaces with excellent weather resistance. The combination of the paint’s high quality ingredients results in a paint film that has a hard surface but is still flexible. The paint film is dirt-repellent and remains cleaner longer than an ordinary house paint.
As a result of dirt-repellence, excellent colour durability and weather resistance, Nordica House Paint provides an extremely long-lasting protection for a timber surface. It is suitable for new primed wooden surfaces and those previously coated with acrylate or oil paint, such as exterior walls, facial boards and weatherboards.
There is very little absorption of water into the Nordica matt paint film, resulting in reduced moisture expansion and subsequent cracking. However, the paint film will allow moisture vapour diffusion, meaning that normal structural moisture can escape through the surface without any adverse effects.
Nordic House Paint is ideal for new and previously with acrylate and oil paint painted wooden surfaces and for industrially primed and/or undercoated wooden surfaces, e.g. exterior walls, fascia boards and weather boards.
New Wooden Surface - Treat the surface as soon as possible. At least the impregnation and priming would be best done in the summer of construction. Remove all loose material, dirt, dust and mildew. If needed, use RENSA FACADE facade cleaner.
Previously Painted or Old Wooden Surface - Replace wooden parts that are in poor condition. Remove loose matter, dirt and dust. Remove loose and poorly adherent old paint.
Wash the surface with Rensa Façade cleaner. Remove the deteriorated paint coats carefully. The adherence of an old thick paint layer to the substrate may have been weakened, therefore the paint should be removed completely although the paint film looks intact. The old paint layer is removed by scraping sanding or by burning off (e.g. by warm-air heater or infrared heater). Secondarily paint remover or blasting can be used. Clean rusty steel components by sanding or wire brushing.
Treat bare wooden surface with clear Woodex Aqua Base priming oil.Once dry prime the timer with Nordica Primer.
If the surface is an old wooden surface primed with oil or painted with oil paint, use a solvent-borne alkyd primer such as Teknos Futura 3 Adhesion Primer.
Rusting steel surfaces, prime with anti-corrosion paint.
Also the end grains of industrially primed and/or undercoated timber need to be treated with priming oil or primed before applying the top coat. Sealing will remove the danger of water being taken in by the end grain, causing splits in the timber and paint film.
Dilute the paint 5 - 10 % by volume by water as required.
Nordica House Paint can be applied by Brush or by Airless Spray
If the paint is applied by airless spray, finish by brush.
Recommended airless spray nozzle is 0.015 - 0.019".
The surface to be painted has to be dry. The moisture of the wood must be below 20 % of the dry weight of the wood. During the application and drying period (also the following night after the painting work needs to be taken into account), the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %.