Beeckosil Fine is available in more than 300 absolutely non-fading mineral colour tones as produced in the BEECK colour range. The range is separated into Colour Groups 1-4.
Additionally, we are also able to tint this product to match your exact specification from any other colour chart or sample. Simply select ‘Tinted to your colour’ from the dropdown list and enter the reference code for the colour you want.
The UV resistance of mineral paints means that the colours do not fade and there shouldn’t be a discernible difference between buildings painted in the same colour at different times.
If you are unsure about your colour options or choice, we also have plenty of ideas to set the ball rolling in our colour section where we have added a number of widely used colour ranges. Or, alternatively, to discuss your options please call us on: 01179 511537
Beeckosil Fine can be used on a range of mineral based exterior surfaces and dries to a rich colour that does not fade. As the product bonds with the substrate, the finish is extremely hard wearing, durable, weather resistant, and easily cleaned. The finished effect creates a cloth-matt look and a classic and timeless mineral aesthetic. Beeckosil Fine can be used for both conservation of listed buildings and for contemporary architecture.
This product is specifically for all uncoated mineral substrates including:
Lime Render and Plaster
It is not suitable for application on:
For previously coated surfaces such; as those which have been painted with masonry paint, K-Rend and Pebbledash use Beeck Renosil NOT Beeckosil.
Surface Preparation –
To get the best results make sure the surfaces are clean, dry, firm, stable and free from efflorescent and separating substances. Carefully repair damaged surfaces, including those with chips and cracks, before application. If cracks and defects exist, use Beeck Quartz filler to correct them and ensure a uniform surface. Furthermore, if any algae are present on the substrate, treat with a fungicide wash before applying Beeckosil Fine.
We highly recommend trying out a test area before application to entire surface.
Application and Thinning –
When applying Beeckosil, prepare substrate as recommended and carefully cover and protect surfaces which are not to be treated – especially glass, ceramics, window sills, expansion joints, lacquer and anodic coatings. Where possible, and for best effects, try to get an uninterrupted coating process.
For optimal coating and application, adjust and thin Beeckosil fine with Beeck Fixative before application. For maximum protection and durability, we recommend applying a double coat of Beeckosil Fine to your exterior substrate.
The base coat of Beeckosil should be thinned with 10-20% Beeck Fixative and apply the top coat no sooner than 12 hours later. The top coat of Beeckosil should be thinned with a maximum of 5% Beeck fixative. Or, in case of high surface saturation, thin the top coat with 5% water instead of Fixative for diluting.
As a general guideline we do not suggest Beeckosil fine is applied in outside temperatures below +8˚C. Likewise, do not apply in wet, frosty, or excessively warm weather conditions. Only apply to properly prepared substrates.
For specific render preparation and application notes, please see the PDF located in Further Resources.
Suitable for brush, roller and spray application –
Spray Nozzle: 0.79mm/0.031 inch
Always sieve the product before use.
Apply uniformly and as a thin coat then use a brush or roller to uniformly lay-off.